Click here for useful tips on pressure washing
Click here for tips on choosing a contractor |
When using a Pressure Washer follow these steps:
-
Grasp the gun and lance with Both Hands, hold spray nozzle 5-24 inches away from cleaning surface.
-
Pull trigger to spray water.
Do not allow unit to run more than 3 minutes without pulling the trigger gun. Letting the unit idle for too long can cause the pump to burn out. If it is necessary to stop your work for more then 3 minutes, turn off the engine.
Nozzle Usage:
-
0 Degree - red nozzle: Narrow and powerful stream of water. Used for difficult to remove stains.
-
15 Degree - yellow nozzle: Uses a small angle of spray for focused cleaning.
-
40 Degree - white nozzle: Larges angle of spray used for cleaning surfaces quickly and for rinsing.
-
65 Degree - soap nozzle: Soap tip is used in conjunction with the cleaning fluid. This is the only nozzle that can be used with cleaning solutions.
Chemical Injectors:
The chemical injector is used in conjunction with the Soap Nozzle and a Cleaning Solution. The PSI will be much lower in this application. The soap will only draw with High Flow and Low Pressure.
- Attach the soap nozzle to the tip of the wand.
- Drop soap hose filter in detergent container.
- Spray with gun and normal.
|
