How to Use Surface Cleaner.
When using a Pressure Washer follow these steps:
-
Grasp the gun and lance with Both Hands, hold spray nozzle 5-24 inches away from cleaning surface.
-
Pull trigger to spray water.
Do not allow unit to run more than 3 minutes without pulling the trigger gun. Letting the unit idle for too long can cause the pump to burn out. If it is necessary to stop your work for more then 3 minutes, turn off the engine.
Nozzle Usage:
-
0° - red nozzle: Narrow and powerful stream of water. Used for difficult to remove stains.
- 15° - yellow nozzle: Uses a small angle of spray for focused cleaning.
- 40° - white nozzle: Largest angle of spray used for cleaning surfaces quickly and for rinsing.
- 65° - soap nozzle: Soap tip is used in conjuction with the cleaning fluid. This is the only nozzle that can be used with cleaning solutions.
|
